- For swimming pools
- Low incidence of pH changes
- Surfactants: partial tolerance
- Temperature: 45 °C max.
- Pressure: 0.5 bar max.
| Measured parameter: | Free chlorine |
| Chlorination additives: | Inorganic compounds, such as NaOCl – Ca(OCl)₂ – gaseous chlorine, chlorine by electrolysis, plus stabilizer isocyanuric acid up to 500 mg/l.
Surfactants: partial tolerance |
| Measuring system: | Closed cell with 3 electrodes and electrolyte |
| Supply voltage: | 12 … 30 V DC, (Load = 500 to 900Ω) |
| Output signal: | 4 … 20mA, screw connectors (2 x 1 mm²) No galvanic insulation |
| Operating temperature: | 1 to 45°C Automatic temperature compensation |
| Operating pressure: | 0.5 bar max. (No vibrations, no pulsating flow) |
| Flow rate: | About 30 l/h |
| pH operating range: | Between 4 and 12 pH (low incidence of pH changes) |
| Interferences: | Incidence of ClO₂ and O₃ on measuring signal |
| Zero adjustment: | Not necessary (from factory) |
| Slope calibration: | Only 1 point with BAMOPHAR 194 according to directive DPD-1 |
| Materials: | PVC-U, PEEK and AISI 316 Ti |
| Dimensions: | O.D. 25mm, length 220mm (4-20mA) |
BAMO CC1 free chlorine sensor is suitable for treatment of water for swimming pool, thermal water (clear water, seawater).