- Optic-luminescent measurement
- Range: 0 to 20 mg/l
- Easy and reduced maintenance
- Temperature-compensated signal
- Body: Or stainless steel, or titanium
- Applications:
- Urban wastewater treatments (nitrifying / denitrifying process)
- Treatment of industrial effluents
- Monitoring of surface waters, coastal waters, aquariums
- Fish farming and aquaculture (fresh water, sea water)
- Drinkable water
| Principle: | Optic-luminescent technology |
| Measurement range: | From 0.00 up to 20.00 mg/l 0.00 to 20.00 ppm 0 to 200 % |
| Resolution: | 0.01 |
| Accuracy: | ± 0.1 mg/l ± 0.1 ppm ± 1 % |
| Response time: | 60 seconds for 90 % of the final value |
| Fluid environment: | Not necessary circulation |
| Operating temperature: | 0 to +50 °C |
| Temperature compensation: | Through a built-in NTC sensor Temperature compensation in the range 0 to 40°C |
| Accuracy: | ± 0.5 °C |
| Interface: | For connection to BAMOWIZ 452 |
| Voltage supply: | 5 to 12 V |
| Mass: | AISI 316 version: 450g (including cable) Titanium version: 300 g (including the cable) |
| Materials: | Wet parts: AISI 316 L passivated, or, Titanium |
| Pressure limit: | 5 bar |
| Cable: | 6-wire shielded cable; External PUR sheath |
| Protection: | IP 68 |
Bamox 453 dissolved oxygen sensor, applies the optical luminescence measurement technology approved by ASTM International Method D888-05. This method confers many advantages:
- High accuracy even for a low concentration of oxygen
- Reduced operating cost: Interchangeable sensor-end
- Optimized maintenance: No signal drift
- Easy commissioning: No necessary calibration
- Suitable for all environments: No consumption of oxygen
- Simplified installation: Direct immersion (no flow-cell)
With the integrated pre-amplifier and digital signal, the sensor is highly resistant to electrical noise. The measured value of dissolved oxygen is automatically compensated of variations of temperature, pressure and salinity, then transmitted to the Bamowiz 452 monitor. The sensor-end is easy to replace for an easier maintenance task. The compact and robust probe is available or in passivated 316 L stainless steel, or in titanium for applications in seawater and corrosive environments.