- Water treatment, drinkable quality and sea-water
- Surfactants: partial tolerance
- Low incidence of pH changes
- Operating temperature 45 °C max.
- Operating pressure 3 bar max.
| Measured parameter: | Total chlorine (Free + combined chlorine) |
| Chlorinating agents: | Inorganic compounds additives: NaOCl; Ca(OCL)₂; gaseous chlorine; chlorine produced by electrolysis
Surfactants: partial tolerance |
| Measuring system: | Closed cell with 3 electrodes and electrolyte |
| Output signal: | 4 … 20mA, 2 screw terminals (2 x 1mm²) No galvanic insulation |
| Operating temperature: | 1 to 45°C Automatic temperature compensation |
| Operating pressure: | 0.5 bar max. (without securing collar) 3 bar (with securing collar No vibrations, no pulsating flow |
| Flow rate: | About 30 l/h |
| Supply voltage: | 12 … 30 V DC; Load: 500 to 900 Ω |
| pH operating range: | pH 4 to pH 12 (low incidence of pH) |
| Conductivity: | From 10 µS/cm up to 50 mS/cm (sea-water) |
| Interferences: | Incidence of ClO₂ and O₃ on measuring signa |
| Zero adjustment: | Not necessary (from factory) |
| Slope calibration: | Only 1 point with BAMOPHAR 194 according to directive DPD-1 |
| Materials: | PVC-U; PEEK, AISI 316 Ti |
| Dimensions: | O.D. 25mm, length 220mm (4-20mA model) |
BAMO CP4 total chlorine sensor is suitable for water treatment (drinkable quality water and sea water).